Advanced Motorized Torque test stand

Computer Control:

• A bi-directional RS-232 port is provided to interface with a PC. For full control from a PC a command set is provided.
  The following additional items are required for PC control:
  - Model Series 7i/5i force gauge
  - 09-1162 multi-function cable
  - 09-1056 serial cable

Digital Angle Indication:

• Rotational travel is indicated in degrees or revolutions, with output of angle data.

Programmable Angle Limits:

• The TSTM-DC can stop at or cycle between programmable upper and lower angle limits. Programmable in degrees or revolutions.

Overload Protection:

• Protects the torque sensor against overload (requires a Series 7i/5i force gauge and 09-1162 multi-function cable). The desired percentage of full scale of the sensor can be user-programmed.

Auto-return:

• The torque table rotates to an angle limit or torque set point (requires a Series 7i/5i force gauge and 09-1162 cable), stops, and reverses direction at full speed to the other angle limit or torque set point.

Cycling / Dwell Time:

• Same as Auto-return, but with the ability to program the number of cycles up to 99,999 cycles. Dwell time allows the operator to program the length of time, up to 9,999.9 seconds, in 0.1 second intervals, for which the torque table pauses between cycles. Independent CW and CCW speeds may be programmed.

Programmable Button Functions:

• Expands CW and CCW button operation to three user-configurable modes:
  1. Maintained (standard): short push produces continuous motion until STOP is pressed
  2. Momentary: torque table rotates only while the button is pressed
  3. Auto: short push produces maintained motion, while holding the button down will produce momentary motion

Independent Speeds:

• Configurable speeds for CW and CCW directions.
• Selectable speed units of measurement (RPM and °/s)

Password protection

• Prevents unauthorized changes to test parameters.